MIL-C-21041C
(e) Class of finish required (3.5.1 and 6.1).
(f) Color of Class 1 finish required if other than DOD Gray (3.5.1). (g) Level of packing and packaging required (5.1 and 5.2).
(h) Special inspection or testing required.
*6.3 Note 1. The gage of metal used in the fabrication of angles and panels covered by this specification
shall be dimensionally defined by the thicknesses specified in the "Manufacturers' Standard" of the American Iron and Steel Institute. As these are only approximate thicknesses, they are listed only for guidance and are not for inspection purposes. The acceptability of the thickness of metal furnished shall be determined per paragraph 3.1.1.
GAGE NO. |
12 |
13 |
14 |
18 |
22 |
APPROX. THICKNESS |
0.1046" |
0.0897" |
0.0747" |
0.0478" |
0.0299" |
6.4 Note 2. The margins of this specification are marked with an asterisk to indicate where changes (additions, modification, corrections, deletions) from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the previous issue.
CUSTODIANS: PREPARING ACTIVITY: Air Force - 84 Air Force - 84
Army - GL
Navy - YD PROJECT NUMBER:
7125-0093
8
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business